SHAFT MIXER
Barl Products Previous Overview Next Barl shaft mixers are used for continuous mixing and conveying of dust-shaped, fine-grained and granulate-shaped bulk material with many different physical properties. Paddle mixers, screw mixers and toothed screw mixers are used with two or four shafts. Voriger Nächster Request
PRECISION METERING DEVICE
Barl Products Previous Overview Next BARL precision metering device serve even dosage of smaller dust-shaped and fine-grained bulk materials. The bulk material must be ready to be conveyed and flowing. With the help of the agitator in the inlet area, a near-constant filling degree can be ensured. Resulting agglomerations in the silo can be chopped […]
DISCHARGE AID
Barl Products Previous Overview Next BARL discharge aid are used to empty silos and hoppers for dust-shaped, fine-grained and granulate bulk materials up to 30 – 40 mm with many different physical properties. Our discharge aid loosens up the bulk material, destroys bridges and promotes the mass flow. The outer cone is firmly connected to […]
TWO-AND THREE WAY DISTRIBUTOR
Barl Products Previous Overview Next BARL two-and three way distributor can spread out the bulk material flow on two or three exits. The non-switched directions are closed by the switching valves. Our two-and three way distributor are very robust and thus suitable for the harshest of uses as well. Our devices can be used for […]
OPTIMIZATION OF OUR PRODUCTION
We optimized our production with new, state-of-the-art processing machines that allow us to increase production speed, improve precision and maximize efficiency at the same time. By using advanced technologies, we can respond more flexibly to customer requests, shorten throughput times and raise the quality of our products to an even higher level. This investment not […]
AGGLOMERATE CRUSHER
Barl Products Previous Overview Next BARL lump crushers are suitable for agglomerates, but not for rock-like products. The bulk material must be fed to the lump breaker in doses, so it cannot draw from the full. Depending on the nature of the product, we build single-shaft and multi-shaft shredders. Our lump shredders are generally equipped […]
DOUBLE OSCILLATING FLAP
Barl Products Previous Overview Next BARL double oscillating flap are usually used as removal element under filters and cyclones or as air closure in pipes. Double oscillating flap require a continuous product addition since these devices cannot be supplied unlimited. In the open condition, the clear passage is free of impairing bottlenecks. Any inspection that […]
FREE FLOW VALVE
Barl Products Previous Overview Next BARL free flow valves are used as closure valves under vessels or in pipes. In the open condition, the clear passage is free of impairing bottlenecks. Free-flow flaps are used for complete emptying of containers. Partial emptying is not possible, since closing is not possible while the product flows. They […]
CHAMBER LOCK
Barl Products Previous Overview Next BARL chamber airlocks are used for transferring and dosing from a pressure or vacuum system and for transferring into pyrolysis reactors and for blocking gases and vapors. As well as for the gassing and degassing of bulk materials A chamber lock consists of 2 shut-off units with an intermediate tank, […]
HEAT EXCHANGER (heating screw/cooling screw)
Barl Products Previous Overview Next Heating screws : are designed as follows depending on the requirements: – In the lower temperature range up to 200°C with trace heating. – In the medium temperature range up to approx. 350°C with thermal heating. – In the high temperature range up to approx. 700°C with induction heating. Cooling […]